Ultrasonic sensor is a device that can measure the distance to an object by using sound waves. It measures distance by sending out a sound wave at a specific frequency and listening for that sound wave to bounce back. By recording the elapsed time between the sound wave being generated and the sound wave bouncing back, it's possible to calculate the...
IR Multipurpose Sensor. Widely used for line follower and obstacle sensing robot for black and white line and object. 5V operated, easy to interface with wide range of microcontroller. Like ARDUINO,AVR,ARM,8051,PIC,MSP430 etc. Sensing range is adjustable with inbuilt variable resistor. , Digital output.
LM35 is a precision IC temperature sensor with its output proportional to the temperature (in oC). LM35, temperature can be measured more accurately than with a thermistor. It also possess low self heating and does not cause more than 0.1 oC temperature rise in still air.The operating temperature range is from -55°C to 150°C.
The TSOP 1738 is a member of IR remote control receiver series. This IR sensor module consists of a PIN diode and a pre amplifier which are embedded into a single package. The output of TSOP is active low and it gives +5V in off state. When IR waves, from a source, with a centre frequency of 38 kHz incident on it, its output goes low.
AC DC Measuring Voltage Current Small multimeter for your day to day needs If you have basic knowledge about multimeters you can try this small multimeter for basic continuity checks and voltage measurements. When testing the temperature, connect the temperature probe to V 0 mA jack or COM jack. Please refer to the attached instruction manual for the...
He high-performance microchip 8-bit avr risc-based microcontroller combines 32kb isp flash memory with read-while-write capabilities, 1kb eeprom, 2kb sram, 23 general purpose i/o lines, 32 general purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts, serial programmable usart.
Microcontroller : ATmega328P - AU USB to UART Converter : CH340G Power Supply : USB(5V) or External (non-USB) power(7V to 12V) Digital I/O Pins : 14 (of which 6 provide PWM output) Analog Input Pins : 6
Compatible with arduino, raspberry pi, arm, avr, pic, 8051, etc Best suited for gsm based microcontroller projects (better than sim300 and other gsm modems)
25W Iron Soldering Gun Solder Weld Welding Irons 220V
Simple to use, USB to serial base unit for the XBee line All XBee pins broken out Onboard 3.3V regulated supply Reset button Length: 4cm, breadth: 2.5cm, height : 1cm
100% Brand New and High Quality. 63/37 rosin core solder Wire diameter: 0.5mm Gross Weight: 40g/1.06oz Reel Size: 5.5cm x 2.8cm/2.2 x 1 inch Melting point: 361F/183C Good solderability, insulation resistance, No spattering and Non-corrosive.
THIS L293D DRIVER MODULE IS A MEDIUM POWER MOTOR DRIVER PERFECT FOR DRIVING DC MOTORS AND STEPPER MOTORS.
Shift register is a cascade of flip flop, sharing the same clock, in which the output of each flip-flop is connected to the 'data' input of the next flip-flop in the chain, resulting in a circuit that shifts by one position the 'bit array' stored in it, 'shifting in' the data present at its input and 'shifting out' the last bit in the array, at each...
L293D is a typical Motor driver or Motor Driver IC which allows DC motor to drive on either direction. L293D is a 16-pin IC which can control a set of two DC motors simultaneously in any direction. It means that you can control two DC motor with a single L293D IC.
The composition of a PCB generally consists of four layers, which are heat laminated together into a single layer. The material used in PCB includes the following layers Silkscreen,Soldermask,Copper,Substrate.
GPS engine module that features super sensitivity, ultra low power and small form factor